Show off your favorite prints!
#8921
https://flic.kr/p/SL2PF5
https://flic.kr/p/SL2PxQ
https://flic.kr/p/T9xTjr
https://flic.kr/p/SxzQSC

Grabed some stuff off Thiniverse to test certain, edges, curves, holes and overall quality.

Those doing rafts, you need a Gap of 0.80mm to get adhesion and relatively easy release (pliers will give enough torque for a quick snap.)

This is all done with my bad motor that skips about eight times in a row at specific points, very annoying.